The Passive PoE™ - Injector enables to merge the power supply and data to one ethernet cable
and supply them to the devices with PoE port. It is suitable for connecting the devices which actively
support Passive PoE™ such as Wiligear, LigoWave, Mikrotik-routerboard, WRAP, ALIX etc. They can be supplied standardly up to 50 V (the power adapter is not included). Passive PoE™ `s range is normally from 30-40 metres/100-130 ft - the real distance depends on the power supply, type of cable
and powered device.
The Passive PoE™ - Injector is a lower part (computer end) which enables to merge the power supply and data to one ethernet cable and supply the devices with PoE ™ port. It is suitable for connecting the devices which actively support Passive PoE™ such as Wiligear, LigoWave, Mikrotik-routerboard, WRAP, ALIX etc. They can be supplied standardly up to 50 V (the power adapter is not included). Passive PoE™ `s range is normally from 30-40 metres/100-130 ft (the real distance depends on the power supply, type of cable and powered device).
| Pieces: | 1 |
| Weight: | 0.3 kg/0.66 lb |
| Volume (approximate) | 0.00054 m3/0.1 cu.ft |
| Item net weight | 0.03 kg / 0.065 lb |
| 1. | Connect network cable to RJ45 female connector of Passive PoE™ Injector |
| 2. | Connect RJ 45 male connector of Passive PoE™ Injector to lower end device (PC/Hub/Switch) |
| 3. | Connect DC connector of Passive PoE™ Injector to DC power source |
Insert and turn system
| 1. | Insert PoE into the cut-out as shown on picture. |
| 2. | Rotate PoE for about 45 degrees, until you feel click. |
| 3. | Installation is completed. |
 |
Uses existing infrastructure |
|
Cost effective |
|
Original design |
|
Contains Injector and Splitter |
|
Uses DC 5,5x2,1mm connector |
|
Contains no active elements |
Holder for UBNT´s NanoStation™
and RF elements™ StationBox™
Outdoor enclosure for installation
of WISP device and antenna.
Other products from
RF elements.
